5000 Series

• Power on the decoder by pressing the ON button. Give the decoder a minute or two to power on. The main screen of the decoder should look like the below example.

• NOTE: The MENU button is in the center. The OK button is on the lower right.
• Navigate to Menu > Time > Configure GPS time.
• Use the left and right arrow keys to select your correct time zone. Press OK to confirm.
• Press Cancel once to navigate back to the Time menu.
• Select Set GPS Time. Wait for the decoder to connect to GPS.

• Once the decoder finds GPS, you will see a clock at the top of the screen. Make sure this is showing the correct time of day. If not, double-check your Time Zone and sync GPS time again.

• IMPORTANT! Press the green START button on the decoder to enable timing mode.