Final Setup - Confirming your setup is working
- Once everything is configured and all connections are open, your Timing Tab should look like this:
- To test to make sure everything is working, you can trigger a Marker on your timing system by pressing the green Start button.
- You can verify that the Marker made it into RR14 by navigating to the Chip Reads section on the left-hand menu of the Timing Tab. Look for a row that says MARKER.
- Now you can verify that the Marker is in the Chip Reads section of RDS.
- Another confirmation would be to look at the Reads column under your system connections, as well as the Count and Sent columns under your exporter.
- For the exporter, the Count represents the number of raw reads available to be sent. The Sent column represents the number of reads that have successfully been sent to RDS.
- Below, you can see that each timing system has received one passing. The exporters have each sent 2 passings since there are a total of 2 passings in RR14 available to be sent.
