Both of the below errors will alternate with the current time displayed.
GPS time sync warning
This error happens when your decoder thinks it has a time offset that is greater than 0.1s. In most cases, this is because the decoder does not have a GPS fix.
| N | o | P | a | s | s | i | n | g | s | G | P | S | S | Y | N | C | E | R | R | O | R | ||||||||||||||||||
| F | i | l | e | N | o | : | 1 | 0 | I | P | : | 1 | 9 | 2 | . | 1 | 6 | 8 | . | 1 | . | 2 | 0 | 0 | P | r | e | s | s | ||||||||||
| U | p | l | o | a | d | : | o | f | f | A | n | t | e | n | n | a | s | : | █ | █ | █ | █ | █ | █ | █ | █ | S | T | A | R | T | ||||||||
| U | S | B | : | n | / | a | B | a | t | t | e | r | y | : | █ | █ | █ | █ | █ | █ | █ | █ |
GPS sync estimate
When syncing GPS, you might also get an estimated time if the decoder can not get a good GPS fix. Often this is because the system is either inside or has not had a GPS fix for some time. By accepting the estimated time, you allow the decoder to continue functioning in GPS mode. You can leave the decoder outside with a clear view of the sky. This will allow the decoder to update its GPS fix over time.
| S | e | a | r | c | h | i | n | g | G | P | S | . | G | o | o | d | / | W | e | a | k | : | 1 | / | 0 | S | A | T | 1 | : | █ | _ | _ | ||||||
| S | t | a | y | c | l | e | a | r | o | f | a | n | t | e | n | n | a | ! | S | A | T | 2 | : | ||||||||||||||||
| P | r | e | s | s | c | a | n | c | e | l | t | o | a | b | o | r | t | . | S | A | T | 3 | : | ||||||||||||||||
| 1 | 1 | : | 3 | 8 | : | 0 | 5 | . | ? | ? | ? | ( | P | r | e | s | s | O | K | t | o | u | s | e | ) | S | A | T | 4 | : |
Active Extension time sync warning
This error happens when your decoder time is not in sync with the time of your active extension.
| N | o | P | a | s | s | i | n | g | s | A | C | T | I | V | E | S | Y | N | C | E | R | R | O | R | |||||||||||||||
| F | i | l | e | N | o | : | 1 | 0 | I | P | : | 1 | 9 | 2 | . | 1 | 6 | 8 | . | 1 | . | 2 | 0 | 0 | P | r | e | s | s | ||||||||||
| U | p | l | o | a | d | : | o | f | f | A | n | t | e | n | n | a | s | : | █ | █ | █ | █ | █ | █ | █ | █ | S | T | A | R | T | ||||||||
| U | S | B | : | n | / | a | B | a | t | t | e | r | y | : | █ | █ | █ | █ | █ | █ | █ | █ |
The AE will be synced if the time is set in the decoder (GPS time or manual time, both works), but not automatically when in timing-mode.
The warning appears if the time difference is >100ms. If the warning will be shown directly after the sync, you should try to resync as the probability that something went wrong with the sync is given.
Otherwise, such a warning should only appear after a couple of days, or if the decoder doesn't have a solid GPS connection.
If all of the above is not given but the warning appears, we would need to check the AE in our HQs.