Ubidium contains an internal Wi-Fi module which can be used as both a Client (to connect to wireless networks) or can also be set as an Access Point to provide a wireless network. 

When connecting Ubidium via a local Wi-Fi connection you will need to run the RACE RESULT Web Server on your computer in order to connect through RACE RESULT Software. 

If you plan to use Ubidium as a client then please refer to the Wi-Fi settings under the Cloud Upload Settings.

It is only recommended to use Ubidium as an Access Point if you plan to work entirely offline during your event. Note that Ubidium will not share any other internet connections via the Wi-Fi access point so it will not be possible to connect your computer to the internet through Ubidium. 

To enable the Ubidium access point press the third from the top Navigation Button from the main screen to open the Network Settings, then from here press the second Navigation Button to open the WiFi settings. 

Use the top Navigation buttons to first change the Mode from Client to Access Point, use the Directional Buttons to change the selection, and press OK to confirm.

By default the access point name (SSID) will be the device ID, but the password should be changed. To set the password then press the bottom Navigation Button to Configure Access Point, here you can change the SSID and Key using the corresponding Navigation Buttons.

It is not recommended to change the IP settings unless you are familiar with networking. 

When Ubidium is operating as an Access Point it will show as Connected to itself in the Choose connection information.