POWER

Loop power of the active extension.

Set <PARAMETERS>

Set response

SETCONFIG;ACTIVE;POWER;<SelectedPower>[;<ActualPower>]

Get response

GETCONFIG;ACTIVE;POWER;<SelectedPower>[;<ActualPower>]

Where <SelectedPower> is the power that should be configured and <ActualPower> the power that the active extension has actually set (only available if active extension is connected).

CHANNEL

Selected channel.

Set <PARAMETERS>

Set response

SETCONFIG;ACTIVE;CHANNEL;<SelectedChannel>[;<ActualChannel>]

Get response

GETCONFIG;ACTIVE;CHANNEL;<SelectedChannel>[;<ActualChannel>]

Where <SelectedChannel> is the channel that should be configured and <ActualChannel> the channel that the active extension has actually set (only available if active extension is connected).

LOOPID

Selected loop id.

Set <PARAMETERS>

Set response

SETCONFIG;ACTIVE;LOOPID;<SelectedLoopId>[;<ActualLoopId>]

Get response

GETCONFIG;ACTIVE;LOOPID;<SelectedLoopId>[;<ActualLoopId>]

Where <SelectedLoopId> is the loop id that should be configured and <ActualLoopId> the loop id that the active extension has actually set (only available if active extension is connected).

V1LEGACYMODE

Selected V1 legacy mode.

Set <PARAMETERS>

Set response

SETCONFIG;ACTIVE;V1LEGACYMODE;<SelectedMode>[;<ActualMode>]

Get response

GETCONFIG;ACTIVE;V1LEGACYMODE;<SelectedMode>[;<ActualMode>]

Where <SelectedMode> is the mode that should be configured and <ActualMode> the mode that the currently active (only available if active extension is connected). Note: If the latter is not up to date, call GETCONFIG a few seconds after SETCONFIG to get the updated actual value.