Countdown / -up

Function: count up to or down from a specified time

Time format: hh:mm:ss

Accuracy: ±40 ppm

Caution: it is possible to enter non valid minutes (over 59) on the next full minute the minutes will jump to 00

To access and use countdown / - up:

• Press the "Up" button to count up, or the “Down” button to count down
• Use the “Edit” button to set the time to count up or down from
• Enter the desired time using the number pad
• Press “Edit” again to save
• Use the “±10S” button to turn the 10 second pre-countdown on or off
  • “-10” stands for no pre-countdown
  • “10” stands for 10 second pre-countdown
• Press “OK” to start/pause the timer

Clock

Function: displays a normal clock in either 12h or 24h format            

Time format: hh:mm:ss

Accuracy: ±120 ppm

To access and use the Clock mode:

• Press the “Clock” button
• Use the “12Hrs” and “24Hrs” buttons to switch between 12 and 24-hour format
• Use the “Edit” button to set the clock
  • the first digit will start flashing and can be set using the number pad
  • when done setting the time press “Edit” again to save the time

Stopwatch

Function: stopwatch

Maximum time: 99:59.99

Time format: mm:ss.kk

Accuracy: ±40 ppm

To access and use the stopwatch:

• Press the stopwatch button to enter Stopwatch mode
• Use the “±10S” button to turn the 10 second pre-countdown on or off
  • – “-10” stands for no pre-countdown
  • – “10” stands for 10 second pre-countdown
• Press “OK” to start/pause the stopwatch
• Use the reset (not labeled) button to reset the stopwatch when it is paused

Marathon Timer

Function: stopwatch

Time format: hh:mm:ss

Accuracy: ±120 ppm

To access and use the Marathon Timer:

• Press the marathon timer button (not labeled)
• Use the “±10S” button to turn the 10 second pre-countdown on or off
  • “-10” stands for no pre-countdown
  • “10” stands for 10 second pre-countdown
• Press “OK” to start/pause the stopwatch
• Use the reset (not labeled) button to reset the stopwatch when it is paused

Interval Timer

Function: repeats timer until count is reached

Time format: cc.mm:ss

Maximum time: 99.99:59

Accuracy: ±40 ppm

To access and use the Interval Timer:

• Press the “Int” button to enter interval mode
• Press the “Edit” button
  • Set the number of intervals using the number pad
  • Press the “Edit” button
  • Set the time for the f rst interval using the number pad
  • Press the “Edit” button
  • Set the time for the second interval using the number pad
  • Press the “Edit” button
• Use the “Up/Dn” button to decide if the timer should count up to or down from the set times
• Use the “±10S” button to turn the 10 second pre-countdown on or off
  • “-10” stands for no pre-countdown
  • “10” stands for 10 second pre-countdown
• Press “OK” to start/pause the timer