After booting, the decoder is in Test Mode, i.e. it does not store any detections. Instead, it steadily beeps/blinks when seeing a transponder. This way:
- The setup of the system can be checked easily to make sure it detects as expected.
- You do not need to filter any detections in the scoring software from athletes' warm-up before the race.
Timing Mode
The Timing Mode will be started when pressing the START button on the key pad. If not running on day time/GPS time, the time will start from 0:00:00 and the decoder will immediately start processing and recording every tag passing the antenna.
Stopping Timing Mode
The Timing Mode can be stopped by pressing the Cancel button or by selecting the entry Stop Timing in the menu. The system will then be back in Test Mode.
Next time the Timing Mode is started, the system creates a new file for the detections, indicated by a new file number on the main screen. Note that:
- Through the Ethernet interface, only detections from the current file can be read.
- All (old) files can be accessed any time through the browser or USB stick (see Data Connections).
Emergency File
If you forget to start Timing Mode, you can still access an emergency passings file through the Browser Access.
Decoder Passing File
All Decoder timing data will be stored in a passing file on the system. Each file has a unique ID, which is displayed on the main screen of the decoder, where it says File No.
A new passing file is started each time the decoder enters Timing Mode. When Timing Mode is stopped, the current file will be closed, and the next file will be created. If the decoder is in Test Mode, the current file number displayed on the screen will be used once Timing Mode is enabled. A passing is generated each time a transponder is read by the system or when a marker is created. When a decoder is in Timing Mode, all passing will be stored in the active passing file.
When connecting to a Decoder, only passings from the current passing file will be sent. When using Mobile Upload, only the current passing file will be uploaded unless otherwise configured in the Mobile Upload settings.
Passing files are permanently stored on the decoder. These files are small in size, and storage capacity is not a concern. If you ever need to access a past file, here are several ways you can do so.
- Downloading a Passing File from a RACE RESULT Decoder
- System Controls
- Decoder Browser Interface
- Timing System Archives
When locating the correct passing file, here are a few things to note.
- If a decoder has stopped Timing Mode, the next file is created, but it will not contain any data yet. This means the most recent file will actually be empty (shows 0 kb when looking at the file on your computer).
- Each file will show a date created. This can help find the correct file if you don't remember the ID.
Passing files can be read into RR12 following the article Read Passings File.