The current version is always shown in the top left screen corner.

How to Update

When running firmware is 0.9.9 or newer, the stick with the update must be inserted prior to boot and the machine will ask you whether to update or not. After installing the update, your Chip2Go will reboot and ask you again whether to update or not. Unplug the USB drive now, then abort the message. You may be asked to install 2 further updates, which you can't abort. After installing these updates, your Chip2Go is updated and can be used again.

Note: there must not be more than one firmware file on the USB drive and the drive must be formatted as FAT32.

pre-0.9.9

Download the latest update below and copy this file to a USB drive. Connect the USB drive to the Chip2Go machine and after a short while the LED on the programming antenna will start to flash red and Green

Once the LED changes to just green remove the USB drive and the machine will reboot with the new firmware.

Note: there must not be more than one firmware file on the USB drive.

Changes

 

• 1.1.4 - Released June 19th, 2024

  • show reader busy when tag antenna is inactive
  • internal improvements

• 1.1.2

  • Fix date encoding bug in order ID for programmed tags

• 1.0.5d

  • Handle end of roll properly
  • Selectable step width when selecting a USB file
  • Barcodes to enable/disable menu (barcodes attached below)
  • Fixed error with device licking up if a USB file is not selected
  • Feeder timeout race condition fixed
  • Improved feed error handling
  • Fixed crashing issue
  • Other minor improvements

• 1.0.4

  • Readjusted check antenna limits after user feedback

• 1.0.2

  • Not ready message (new number entered while old tag not picked up) is clearer
  • Discard input when not ready for new input
  • Improve handling of tag gaps and roll end in single tag mode
  • Adjust check antenna power
  • Minor improvements

• 1.0.0

  • Massive improvement in non-EU and US tag programming reliability
  • Race condition during programming could lead to a hanging machine, fixed.
  • Pulling tags forward no longer freezes the machine
  • Show programmed tag counter and icon for detected usb devices in status bar
  • Handling of errors reworked
  • USB file reading implemented
  • Log file assistant after crashes
  • Update of system and UHF firmware must be confirmed, progress is shown for UHF firmware
  • Logging reworked, more errors get captured for analysis
  • Internal: Log file retention age and size increased
  • Further smaller fixes and improvements

• 0.9.5

  • Country selection for regulatory compliance
  • Improved programming speed and stability