You should connect either the Passive Antenna or Active Extension to the Decoder before starting the system for optimal performance. 

To power on the Decoder, press the ON button until the display is illuminated. 

The boot process of the decoder may take a few minutes to initialize, especially when using Passive as the UHF reader must also be started during this time. 

By default, when the system starts it will be in TEST mode and the time will not be set, the Startup Options can be changed in the system settings. When in TEST mode times are NOT stored on the system. 

N

o

P

a

s

s

i

n

g

s

T

i

m

e

:

0

0

:

0

0

:

0

0

.

0

0

0

F

i

l

e

N

o

:

1

0

I

P

:

1

9

2

.

1

6

8

.

1

.

2

0

0

P

r

e

s

s

U

p

l

o

a

d

:

o

f

f

A

n

t

e

n

n

a

s

:

█

█

█

█

█

█

█

█

S

T

A

R

T

U

S

B

:

n

/

a

B

a

t

t

e

r

y

:

█

█

█

█

█

█

█

█

If the time is not set then press the Menu button and then select Time Settings, it is recommended to always use GPS time when possible. 

➞

S

e

t

r

u

n

n

i

n

g

t

i

m

e

:

0

0

:

0

0

:

0

0

⬅

S

e

t

s

t

a

r

t

t

i

m

e

:

0

0

:

0

0

:

0

0

S

e

t

G

P

S

t

i

m

e

C

o

n

f

i

g

u

r

e

G

P

S

t

i

m

e

To set GPS time, first, select Configure GPS Time, and then set the Timezone to the correct value for your location, once set press cancel to return to the Time Settings and choose Set GPS Time. The system will now scan for GPS signal to set the time, this should be done outside in an open space away from any buildings. If the system is unable to obtain an accurate enough GPS time it may offer you to accept a less accurate time if available. 

In the event that GPS time is not available, you can alternatively choose to Set Running Time from the Time Settings, you should set the time to the most accurate Time of Day possible. 

As a final option, the decoder can be used without Time of Day and can run counting up from zero, however, this is not recommended as in the event of any errors it can be much harder to troubleshoot. 

Once the time is set press the Menu button to return to the main screen, you must now press the green START button to enter Timing mode, the system will now create a passings file to start recording passings. When in Timing mode the ACTIVE LED will be illuminated. 

To turn the system off, press and hold the OFF button until the screen shows that it is shutting down.