Version 2.3
- Selftest (hold button on startup)
- Blink in store mode (only with V2)
- Features for internal timekeeping to enable endless runtime
Version 2.4
- Fixed problem with missing blink
- ASCII Protocol
- Operation without DTR-Feature now possible
Version 2.5 (MAY 2017)
Released: 2017-05-12
- Greatly improved noise measurement
- Much better and repeatable site survey
- Dual Channel for v2 transponders
- Dual Channel for Loop Box repeat
- Management Box can enable and disable Tracking
- All devices will show you the actual loop power when hitting the loop limit while configuring
- Many bugfixes with beacons
- Many bugfixes and improvements in ASCII protocol
- Devices now shut down on power loss if no loop is connected and no detection is stored in the buffer.
- Greatly improved bootloader.
- Store & Copy feature on Active Extension and USB Timing Box
- other internal improvements and bug fixes
- Devices now report LF and 2,4GHz RSSI in passing (3 bits 2.4GHz RSSI / 8 | 4 bits LF RSSI)
Version 2.6 (APR 2025)
General:
- Many small bug fixes
- 64Bit Tickcount
- Automatic Timestamp REFADJ
- Duplicate search now takes the last 1000x Passings into consideration
- 2048th timing resolution
- Support for new V3 Features
- Battery indication for Honcell Battery
- Improved Battery indication
- Display of actual Loop Power in config mode
- Min 20% Loop Power
- Auto shut down after charging when no loop and no passing so far with message
- Slight improvements on Display/Button UI
- Delayed Beacon Transmission for less confusing beacons in Timing Module
- Rewrite of internal Debug Protocol
- Removed V1 Transponder Compatibility Mode
2.4GHz Interface:
- Constant transceiver recalibration
- Fixed 10khz on antenna port
ASCII Protocol:
- Push Passings
- Push Prewarns
- Linewise CheckSum
- 40Bit 2048th Timestamps
- Extended Passing Data
- Extended Beacon Data
- Signed Temperature reporting
- Removed EPOCHREFADJ1D
- Added new Loop Stati
- Revision Reporting
Loop Box:
- Changed MODE: Store -> Store&Forward (only reliable with V3 transponders)
- Extended Beacon Information (Buffer status, Repeat Success Rate, etc...)
USB Timing Box:
- New MODE: Repeat (no passings via USB in repeat mode)
Management Box:
- New MODE: Kiosk
- Stores last mode before shutdow
- Start/Stop is shown in Track Activation Mode
- Tracking Activation always starts with 100% Loop Power
- Management Boxes show X when on same channel as timing System
- Box will not immediatly switch to a different channel when cycling thru check/kiosk mode
- Multichannel Beacons for Management Box -> Management Boxes will be seen by Timing Systems on different chanel